I have had Xscope installed on a Win10 64bit Pro PC for probably 5 years, working with a Xprotolab plain board. ?It has always had problems with locking up periodically which causes a lengthy delay before it can be restarted. ?I recently flashed the board firmware, Xscope reports v2.40, and the Xscope version is 1.1.0.0, but there was no change in this behavior.
Recently I tried to record and save data for the first time. ?When I press the record button, I am then unable to stop the recording, if I press the stop button there is no response from the GUI. ?I can save a small amount of data to a file, but I cannot load the data, Xscope locks up, the error is: "Xscope.exe has stopped working." I would like to record about 10 seconds of data at 128us / div. ?Should this work?
?
?