Hi Gabriel,
I was the one at the Maker Faire Orlando that lost a couple buttons when I accidentally smashed my watch against the wall.? I found the design files on Thingiverse ( www.thingiverse.com/thing:181812 ), so I'll be good to go once I print them out.? It was the sidebuttons3.stl that I need.? I notice that it's all one piece.? Do I need to separate the buttons, or print them out in flexible PLA, or anything special like that?
The watch is great, btw, total geek heaven.? Thanks for making it!
-Brian
?

Yay, new buttons.? They didn't come out perfect, but they fit, so that's what's important to me.

With all the futzing around that I did, I accidentally had the red wire to the buzzer come off of the board.? A small touch-up with a wee bit of solder fixed that nicely.
?
-Brian

It's great that you fixed it! I was going to tell you that the design on thingiverse is slightly different, I had to remove a little bit of material to avoid overlap with the battery. But if the buttons can be pressed ok then no problem!