Hi,
I have not used my unit for a while & have another PC now.
a) ?When I run up the PC interface it suggests that I upgrade to the latest firmware.
However, I cannot recall which HW version it is and it is NOT printed underneath the board. I assume it is a later HW but I am not sure.
?
b) To install new firmware, I have installed FLIP, however FLIP complains about about AtLibUsbDfu.dll not found & DLL not loaded. When I attempt to upgrade the driver as suggest in the FLIP docs, it says that the current driver is up to date.
Lee
/\r\n/

Are you able to put the device in bootloader mode? If not, then you may have a very old hardware version. The version should be printed on the back of the board.

Aha,/\r\n/ I have the Version sorted out V1.7 (ever so small for ageing eyes)./\r\n/Thanks for the tip " Can you get it into bootloader mode" I then RTFM and presto it mentions pressing K1 (not K4) at power up./\r\n/After that all proceeded OK! firmware update V2.32 Unless there is a more recent update in the download area?/\r\n/I dont have my DOWNLOAD-ID anymore/\r\n/Thanks Gabriel/\r\n/ /\r\n/