Hello,
today I tried using the AWG of the xProtolab. On the intergrated Oscilloscope it didn't show any Output. I hooked my big analog Oscilloscope up and it showed that the Output signal was very low (0.1 Volt) and looked disturbed. Is there anything I can do to repair the AWG (I've already replaced the - 5V Source before).
David

Let's check this first:/\r\n//\r\n/1) Make sure the amplitude is set at max on the settings. Set the wave type to sinewave, with a frequency of 1kHz or so./\r\n/2) With your oscilloscope, measure pin 6 of the microcontroller, you should see your waveform with a 2V peak to peak amplitude.

At Pin 6 the MCU does give me a sinus Wave with approx. 2V peak to peak. But after the Resistor next to the pin (where the trace is going)it gives me only the slightest hint of a signal (at 5mv per division) at the wrong frequency.

Probably the OPAMP is damaged.

Well, it turns out it was the 180k resistor at the xmega output that was blown (resistance too high for my meter). Replaced it with a new one and now it works fine. Don't know how that happened. Hopefully that helps someone.