Hi All,
I have a newly purchased (within the past 2 weeks) Xprotolab - very cool tool. No problems running the NFS o-scope app on my android. With the Interface it seems the software can SEND info to the Xprotolab (turn on/off trace, change scale, etc) but I have no trace on the computer's Interface screen??????
Interestingly, the very first time I installed the driver and Interface software I got a trace. Since then nothing. Can't think of anything I did. I've emptied the usual back of tricks: reboot, reinstall software, drivers, etc.? Any thoughts?
I'm looking at a Arduino-generated square wave. Any issues with port conflicts (doesn't seem to matter)? The options/COM port pulldown is grayed out.
Hope I'm not behind the curve, but I haven't noticed this particular symptom in the forum.
Thanks,
Brian
?
Specs:
OS: W7
splash (firmware) says 2.22
Interface 0.10.4942.3020
Haven't taken it apart to get the hardware version
Using included micro-USB - USB-B cable

Hi Brian
You can try using the XP driver.
Anyway, I am working on a new application that will replace the current one. It will use be multiplatform and use LibUSB drivers. It should be ready next month.
/\r\n/