Gabotronics

The Xprotolab is the first mixed signal oscilloscope with an arbitrary waveform generator in a DIP module. It measures only 1 x 1.6 inches, and can be mounted directly on a breadboard. The Xprotolab can also be used as a development board for the AVR XMEGA microcontroller. The Xprotolab uses an ATXMEGA32A4 microcontroller, it uses the internal ADC with up to 2MS/s and the internal DAC for the arbitrary waveform generator of 1MS/s.

• World's smallest, fully featured oscilloscope, just 1" x 1.6"
• ATXMEGA32A4 microcontroller with 32K Flash, 4K SRAM, 1K EEPROM
• Inputs: 2 Analog Channels, 8 Digital Channels
• Sampling rate: 2MSPS
• Arbitrary Waveform Generator, 1MSPS, using the XMEGA's internal DAC
• 4 Tactile Switches
• USB Connector for power
• PDI interface for programming and debugging
• Graphic OLED 0.96" 128x64 pixels, wide viewing angle
• Very low cost

• Breadboard friendly DIP module.
• No probes needed.
• Power your breadboard: get +5V, -5V, +3.3V, with just a USB connection.
• Keep your attention to the breadboard while measuring.
• The device can be used as graphic display with high level commands

Comments

eustace

I bought one of these, put it on an arduino protoshield, then programmed the arduino to generate a sine wave. Set the awg to sine, plug it into ch1, then plug the arduino sine into ch2. Voila! Lissajous patterns on a chip!
But now I wonder; can this thing run Doom?

Friday 20 May 2011, 12:54

MikeSr39

Info says power needed is 5v to run unit but picture show several units running with three AA batteries, how does this work??

Wednesday 04 January 2012, 12:29

ganzziani

Yes, the device can work with 4.5V

Thursday 05 January 2012, 08:34

Please login to post comments or replies.