Home Forum XMEGA Xprotolab Updating firmware on xprotolab
 Gabotronics Forum :: XMEGA Xprotolab
Welcome Guest   
 Subject :Updating firmware on xprotolab.. 2018-05-24 00:27:59 
Joined: 2012-10-01 19:57:33
Posts: 1


When I use the USB scope windows application it tells me to update my firmware. Also the software doesn't seem to control the scope very well.

I tried to follow the firmware update guide, but Windows 10 will not let me install the USB drivers for the bootloader. When I try to update the driver (per the Amtel guide instructions AN 8429) it says I already have newer drivers and the device remains uninitialized.

I could spin up a VM and try from linux, but the avrdude instructions are very sparse. Do I really only need to run two commands?

I also could not find where it says what hardware version of the scope I have. When it boots it says it's running v2.0.0.



IP Logged
Page # 

Powered by ccBoard