Home Forum XScopes PC Interface Unable to use log file interface
 Gabotronics Forum :: XScopes PC Interface
Welcome Guest   
 Subject :Unable to use log file interface.. 2017-08-23 19:49:04 
sekramer10@outlook.com
Joined: 2015-11-20 21:14:49
Posts: 3
Location

I have had Xscope installed on a Win10 64bit Pro PC for probably 5 years, working with a Xprotolab plain board.  It has always had problems with locking up periodically which causes a lengthy delay before it can be restarted.  I recently flashed the board firmware, Xscope reports v2.40, and the Xscope version is 1.1.0.0, but there was no change in this behavior.

Recently I tried to record and save data for the first time.  When I press the record button, I am then unable to stop the recording, if I press the stop button there is no response from the GUI.  I can save a small amount of data to a file, but I cannot load the data, Xscope locks up, the error is: "Xscope.exe has stopped working." I would like to record about 10 seconds of data at 128us / div.  Should this work?

 

 

IP Logged
Page # 


Powered by ccBoard