Home Forum Oscilloscope Watch Xprotolab as test Jig
 Gabotronics Forum :: Oscilloscope Watch
Welcome Guest   
 Subject :Xprotolab as test Jig.. 2017-11-03 07:06:03 
Gem
Joined: 2017-11-03 11:59:50
Posts: 2
Location

Hi

I want to use Xprotolab plain as test Jig to test my hardware. I want to use Xprotolab to generate following waveform:

Square Wave

time: t0 to t1 -> 0 to 60Hz

time: t1 to t2->hold 60hz

time: t2 to t3 -> 60 to 0hz.

This process is automated and should go on in loop.

To achieve this I was thinking of Using Arduino Uno. Uno shall send commands over serial port to the xprotoblab.

Can anyone please provide the serial protocol datasheet or the format of the commands and the serial data frame?

OR Is there any other way to achieve above task?

Thanks

IP Logged
 Subject :Re:Xprotolab as test Jig.. 2017-11-04 08:38:49 
Gem
Joined: 2017-11-03 11:59:50
Posts: 2
Location

So,

I was able to solve my above problem. I used the commands mentioned in the manual.
For e.g. to set square wave send command 0x62 (command 'b') 0x25 (AWG waveform type 37 dec) 0x02 (square wave).

Similarly apply this logic for other parameters.
Baud should be 115200.

Thanks

IP Logged
Page # 


Powered by ccBoard