Home Forum Oscilloscope Watch button design on thingiverse
 Gabotronics Forum :: Oscilloscope Watch
Welcome Guest   
 Subject :button design on thingiverse.. 2014-09-16 01:41:30 
brian
Joined: 2013-07-05 13:16:56
Posts: 2
Location

Hi Gabriel,

I was the one at the Maker Faire Orlando that lost a couple buttons when I accidentally smashed my watch against the wall.  I found the design files on Thingiverse (http://www.thingiverse.com/thing:181812), so I'll be good to go once I print them out.  It was the sidebuttons3.stl that I need.  I notice that it's all one piece.  Do I need to separate the buttons, or print them out in flexible PLA, or anything special like that?

The watch is great, btw, total geek heaven.  Thanks for making it!

-Brian

 

IP Logged
 Subject :Re:button design on thingiverse.. 2014-09-28 12:16:07 
brian
Joined: 2013-07-05 13:16:56
Posts: 2
Location

Yay, new buttons.  They didn't come out perfect, but they fit, so that's what's important to me.

watch new buttons

With all the futzing around that I did, I accidentally had the red wire to the buzzer come off of the board.  A small touch-up with a wee bit of solder fixed that nicely.

 

-Brian

IP Logged
 Subject :Re:button design on thingiverse.. 2014-09-28 14:15:00 
ganzziani
Joined: 2012-04-02 15:42:39
Posts: 463
Location: Sarasota, FL
 
It's great that you fixed it! I was going to tell you that the design on thingiverse is slightly different, I had to remove a little bit of material to avoid overlap with the battery. But if the buttons can be pressed ok then no problem!
IP Logged
Gabriel Anzziani
Page # 


Powered by ccBoard